10
6,Read the voltage in the display.
DC/AC VOLTAGE MEASUREMENTS:
If the polarity is
reversed, the display will show (-) minus before the value
VIII. 200k
RES IS TANCE MEAS UREMENTS
1, Set the function switch to the highest
200k
position.
2, Insert the black test lead banana plug into the negative
COM jack
3, Insert the red test lead banana plug into the positive
jack.
4, Touch the test probe tips across the circuit or part under
test. It is best to disconnect one side of the part under test so
the rest of the circuit will not interfere with the resistance
reading.
5, Read the resistance in the display
X. Battery Replacement
1,When the low battery symbol
appears
on the LCD,
the six 1.5V ‘AA’ batteries must
be replaced.
2, Turn the meter off and remove the test
leads.
3, Unclip the tilt stand from the rear of the
meter.
4, Remove the four Phillips head screws
holding the battery cover.
5, Remove the battery compartment cover
.
6, Replace the batteries observing polarity.
7, Affix the rear cover and secure the screws.
8, Reattach the tilt stand.
