Preparing for work
1. Unpack the Milling Cutter. If the device is brought from a cold
place to a warmer place, it should be unpacked not earlier than after
two hours.
2. Place the power unit onto a plain, rigid, and stable surface such as
a working desk. Select a position of the power unit in such a manner
that its front panel can be seen in full and its controls can be easily
accessed. Place the pod in the immediate vicinity of the power unit.
3. Connect the power cable plug of the handheld milling cutter to
the relevant jack at the front panel of the power unit.
Attention! The plug has a ping and the jack has an inlet. This is the
key to the correct connection; the relevant ping should get into the
relevant inlet.
4. Check if there is a tool or a standard temporary cover in the collet
clamp of the handheld milling cutter.
5. Never forget to make sure that the collet clamp is locked and that
the collet holds the tool firmly and does not let it fall out.
6. Take the tool with your fingers carefully and turn the shaft of the
handheld milling cutter a few times. Make sure that the tool can
rotate together with the collet and that the rotation is done freely
without external noise and vibration.
7. Put the handheld milling cutter onto the pod in such a manner
that it does not block your access to the front panel of the power
unit.
Attention! It is not recommended to put the handheld milling cutter
as well as any other tools and caps onto the upper lid of the power
unit. Use the pod instead.
8. Plug the power cable in the wall socket.
9. The milling cutter is now ready for work.
11
Changing the tools in the PRO and EXTRA configurations
1. Switch off the tool rotation
2. Wait until the tool rotation stops completely
3. Use your hands to
move the clamp lock
into the '
R
' direction.
4. You must hear
a distinctive click
5. Extract the old tool
6. Set the new tool
into the clamp
7. Use your hands to move
the clamp lock
into the '
S
' direction until
a distinctive click is heard
Pedal
The pedal is intended for activating and deactivating the rotation
function with the help of a foot. Depending on the configuration
option, the pedal may sometimes not be a part of the equipment
supplied. However, users can purchase the pedal as a separate piece
of equipment.
