Multi-Tech MT5634ZPX, Руководство пользователя

Страница: 48 / 108

MT5634ZPX
48
Owner’s Manual
Command: D s Dial
Values:
s = dial string (phone number and dial modifiers)
Default: none
Description: Dial telephone number
s, where s may up to 40
characters long and include the 0–9, *, #, A, B, C,
and D characters, and the L, P, T, V, W, S, comma
(,), semicolon (;), !, @, ^ and $ dial string modifiers.
Dial string modifiers:
L Redial last number. (Must be placed immediately
after ATD.)
P Pulse-dial following numbers in command .
T Tone-dial following numbers in command (default).
V Switch to speakerphone mode and dial the
following number. Use ATH command to hang up.
W Wait for a new dial tone before continuing to dial.
(X2, X4, X5, X6, or X7 must be selected.)
S Dial a telephone number previously stored using
the &Zn=x command (see &Zn=x command for
further information). The range of n is 0-3.
, Pause during dialing for time set in register S8.
; Return to command mode after dialing. (Place at
end of dial string.)
! Hook flash. Causes the modem to go on-hook for
one-half second, then off-hook again.
@ Wait for quiet answer. Causes modem to wait for a
ringback, then 5 seconds of silence, before
processing next part of command. If silence is not
detected, the modem returns a NO ANSWER code.
$ AT&T’s call card tones detection.
^ Disable data calling tone transmission.
Command: DS=
n Dial Stored Telephone Number
Values: n = 0–3
Default: none
Description: Dial a number previously stored in directory number n
by the &Zn=x command .
Example: ATDS=3