Multi-Tech CallFinder CF100FX2-G, Быстрый старт

Страница: 10 / 12

General Setup
Prerequisites:
•
You must have the SIM chip from your wireless service provider.
•
A small, needle-nose pliers is helpful for inserting the SIM into
its receptacle.
1. Remove the CF100 CallFinder unit from its shipping box.
2. Use a small Phillips screwdriver to remove the SIM cover screw that is
closest to the edge of the chassis. Loosen the second SIM screw
slightly, rotate the cover 180 degrees, and then re-tighten the second
SIM screw slightly to keep the SIM compartment open.
3. Orient the SIM to match the marking in the SIM compartment (the
notched part of the SIM should be near the outer edge of the
CallFinder unit). Insert the SIM into its receptacle (a small needle-
nosed pliers can be helpful for this). Loosen the SIM cover screw
slightly, rotate the SIM cover 180 degrees to its closed position, and
tighten both SIM cover screws.
4. Attach the antenna to the CallFinder.
5. Be sure that the “VOICE/DATA” switch is in the VOICE position.
6. Connect power to the CallFinder.
7. Connect the RJ-11 cable to the appropriate receptacle on the rear of
the CallFinder.
10 Multi-Tech Systems, Inc.