7
Configuring the job computer for work
Entering the geometry
44
V4.20191001
30322453-02-EN
Configuring the job computer for work
Before you start working, you must configure the job computer for the work. You must perform the
configuration of the job computer on the “
SETTINGS
” screen.
Note that depending on the model of the slurry tanker, not all of the parameters can be configured.
To reach the “
SETTINGS
” screen:
1.
On the work screen, press:
⇨
The “
SETTINGS
” screen appears.
⇨
You can see parameters and function icons for the configuration.
2.
If the desired parameters or function icons cannot be seen directly, press
to scroll
to the next page.
⇨
You can perform the configuration.
Entering the geometry
The geometry of an agricultural implement is defined as a series of parameters describing its
dimensions.
The geometry is important particularly for all systems that are GPS-controlled.
The distances you enter depend on whether the implement is towed, mounted on the tractor or self-
propelled.
1.
On the work screen, press:
> (
) >
⇨
The “
GEOMETRY
” screen appears.
⇨
On the screen, you can see which measurements need to be taken and where they can be
entered.
2.
Enter the measured values. With mounted implements that have a boom that is not straight, but
rather curved towards the front, you must enter the values for the individual sections. With
and
, you can switch between the sections.
3.
- Optionally, you can change the name of the mounted implement.
4.
- Optionally, you can call up the “
GEOMETRY / Section-Control
” screen.
5.
Configure the parameters
⇨
You have configured the geometry.
7
Procedure
7.1
Procedure
