Configuring the job computer
Configuring sections
7
30303187-02-EN
V1.20180921
67
1.
Switch to the “Boom” screen:
>
.
⇨
The “BOOM” screen appears.
⇨
Here, you can see the set working width, the number of sections and the number of nozzles.
The two last values may not be changed.
2.
- Press.
⇨
The “NUMB. OF NOZZLES” screen appears.
3.
Here, you can enter the number of nozzles for each section. Multiple nozzle holders count as
one nozzle in this case.
⇨
With each change, the number of nozzles changes on the “BOOM” screen.
Switching sections off permanently
You can permanently switch off any section. This is useful, for example, if the tramlines on the field
are designed for a smaller field sprayer than yours.
Switching off the outer sections has the following effects:
▪ With TRACK-Leader: The newly calculated working width will not be taken into account for the
calculation of the headland width.
▪ With SECTION-Control: After switching off the outer sections, you will need to change the “Line
spacing” parameter so that the distance between the guidance lines matches the actual working
width. You cannot change the “Working width” parameter.
▪ The actual working width changes. However, as the field sprayer has not changed:
– Do
not
change the “Working width” parameter.
– Do
not
change the field sprayer geometry.
Permanently switched off sections are marked in white on the work screen
1.
Switch to the “Boom” screen:
>
.
⇨
The “BOOM” screen appears.
2.
- Press.
⇨
The “SECTIONS” screen appears.
⇨
For each section, you can see one of the following icons:
- Section activated
- Section deactivated.
3.
For each section, you can select and change this icon.
Procedure
7.5.2
Results
Procedure
