Muller Elektronik ISOBUS TRAIL-Control, Руководство оператора

Страница: 18 / 37

5
Operating the system
Steering in automatic mode
18 V2.20160912 30322332-02-EN
5. or - Switch on TRAIL-Control. By pressing again, you can switch off
the system.
⇨ The system is switched on, however, it is only working in manual mode. This means that
you must actuate a function icon to steer the trailed implement. [
➙
18]
⇨ New icons appear on the work screen [
➙
10].
⇨ On systems with drawbar steering:
⇨ On systems with stub axle steering:
You can now read the following chapter:
▪ To obtain more information on the icons on the screen: Layout of the work screen [
➙
10]
▪ If you still have to configure the system: Configuring TRAIL-Control [
➙
23]
▪ If the system has already been configured:
– Steering in automatic mode [
➙
18]
– Steering in manual mode [
➙
18]
Steering in automatic mode
When you work in automatic mode, the trailed implement is steered automatically.
The gyroscope measures the change in direction of the tractor and the job computer calculates the
required angle for steering the trailed implement.
The icons on the work screen show the direction in which the trailed implement is being steered.
Steering in manual mode
In manual mode, you must steer the trailed implement manually.
Drive in a curve to the right as follows:
5.2
5.3
Procedure