Mounting and configuration
Connecting the GPS receiver to a terminal
3
V7.20170405
9
Connecting the GPS receiver to a terminal
NOTICE
Terminal connector supplying power
Potential damage to the terminal from a short-circuit.
◦ Switch the terminal off before plugging in or removing the connector.
This is how you connect the GPS receiver to a terminal:
1.
Switch off the terminal.
2.
Guide the cable of the GPS receiver into the vehicle cab.
3.
Find the appropriate RS232 connection on the terminal. Refer to the operating
instructions for the terminal to find out which connection this is. On most Müller-
Elektronik terminals, this is connection C
.
⇨
You have now connected the GPS receiver to the terminal.
Activating the driver of the GPS receiver on a terminal
You will need to activate the GPS receiver differently depending on where you have
connected it.
Version
Driver
Via the terminal's serial interface
"AG-STAR, SMART-6L" or "GPS_STD"
Via the TRACK-Leader TOP steering job
computer
"PSR CAN"
Via the TRACK-Leader AUTO steering
job computer
"TRACK-Leader AUTO"
You can read how to activate a driver in the operating instructions for the terminal.
Configuring the GPS receiver
The GPS receiver can be configured differently for various terminals. You can find
out how to do this in the operating instructions for the terminal.
The following tables show the values which you can select in the parameter
"correction signal" during configuration:
3.2
Procedure
3.3
3.4
