Two-seater High-back Reclining Sofa
One-seater High-back Reclining Sofa
Instructions for assembly and use
Retain this for future reference
Thank you for purchasing this product.
Please read this sheet before assembly and use.
Please keep this sheet in a safe place for future
reference.
Please make sure you read this before assembly
* Assembly requires at least two persons.
* A screwdriver is not included, so please use your own Phillips head
screwdriver.
* The assembly illustration shows the two-seater model, but
the same assembly also applies for the one-seater.
Cautions
Cautions
Parts List
Assembly of body and wooden legs
How to recline back/headrest
Lever installation
Completed assembly
Precautions for use
Back angle adjustment
Headrest angle adjustment
* Please use properly after checking the enclosed “Precautions for use”.
If the sofa is set and used in the same
beneath the sofa's legs may become
dented or damaged.
Always place the sofa on top of a carpet or
mat, etc.
When lowering the back:
Lower the back with the lever lifted and set the
angle by releasing the lever at your preferred
angle.
When raising the back:
The back will be raised
when the lever is lifted.
The headrest can be adjusted manually to 6
Match with the back reclining angle to reach
your preferred angle.
Lock
20110706
In this position,
the gear lock
will be released.
Maintenance inspections
Periodically inspect and tighten
screws.
Body
Wooden legs
Hexagonal bolts
Spring washers
Two-seater
One-seater
Spanner
Remove
Remove
Step 1
Step 3
Step 4
Step 2
Felt
Lever
Lever
concealment
Lever concealment
Lever
concealment
Hook and loop
Remove the hook and loop
fastener for lever concealment
on the left/right of
body.
body is visible, and remove Phillips
screws using your own screwdriver.
Once again close the lever concealment,
attach the hook and loop fastener to the
Felt sticker
2S: 2-seater/1S: 1-seater
Lever
Phillips screws
2S
2S 1S
2S 1S
2S
1S
1S
* Note 1
* Note 1
* Note 1
* Note 1
Parts , and are assembled in
body
in advance. Before assembling, please remove
them using spanner and your own Phillips
head screwdriver.
Please lay down a carpet or rug
before assembly work in order to
prevent damage.
* Use your own Phillips head
screwdriver.
* The lever can be installed on
the left or the right.
6 lev
els
Re
lea
se
Turn body upside-down, loosen
hexagonal bolts and spring washers with
spanner, and remove these from body.
Align the front and back of wooden legs as
per the illustration on the right.
Lightly screw hexagonal bolts and spring
washers into all four of the screw holes in
body through the screw holes of the wooden
