T H E W O R L D P O W E R I N A N C H O R I N G S Y S T E M S
fig i
fig ii
fig iii
fig iv
fig v
fig vi
fig
Figure(l)
Locate the windlass centrally fore and aft. Check that
the chain leads unhindered to the anchor roller. The chain leads
onto the starboard side of the gypsy, wraps around 180° and falls
below deck through the chain pipe (hawser). Ensure there is
sufficient room around the windlass to allow full rotation of the
windlass manual/clutch handle (if supplied).
Figure (ii)
The centre height of the gypsy must be in the same
plane as the chain lead from the bow roller. If the deck is angled
(fore & aft) or curved (port to starboard) a suitably shaped
mounting block will be required to spread the load evenly over
the deck surface and mount the windlass base on a level and
even footing.
Figure (iii)
Place the shaped mounting block (if required) onto the
deck. Using the layout template supplied, mark the mounting
centres and drill the holes, (Refer template).
Figure (iv)
Apply an appropriate sealant to the base plate,
gasket and mounting block (if required) and carefully tighten the
nuts & washers onto the threaded studs under the deck. Remove
excess sealer.
For Aluminium or Steel hull vessels, it is important to insulate the
windlass with a non-conductive gasket to avoid corrosion. This
also applies below deck with the mounting bolts, nuts and
washers.
Where the deck construction is light or of foam sandwich
construction, a plywood stiffener of at least 16mm (5/8") should
be fitted to the underside of the deck to spread the load and to
prevent the bolts from pulling through the deck. Large diameter
washers on the underside of the stiffener assists to spread the
load.
Figure (v)
1. Mount the windlass from above as shown.
2. From below, place washers and nut on each stud and tighten.
Figure (vi)
3. Locate adaptor and align holes.
4. Fasten using cap screws provided.
Figure (vii)
5. Grease shaft and key, slide geardrive onto shaft ensuring key is
aligned. Rotate gearbox to prefered mounting position and
secure with bolts provided.
6. Locate gearbox and bolt through adaptor.
7. Place washers and bolt in the end of the shaft and tighten / Fit
circlip.
NOTE: On assembly, grease all moving parts and deck plate grease
nipple with a Lithium/teflon based grease. The Motor/geardrive
assembly should be protected with anti-corrosion film or grease tape.
Vii
23/12/2014
www.muir.com.au
4
Содержание STORM VR 2500
