Mueller HYDRO GUARD HG-11 Standard, Руководство пользователя

Страница: 14 / 28

Page 14 of 28
Manual Flushing
Manual flushing allows user to test the Hydro-Guard® unit or a program for a specified
run time.
Make sure controller is in Idle Mode.
1) Press and hold RIGHT ARROW until HAND icon is displayed. The station number
(always #1) will be displayed in lower left side of display along with RUN TIME.
2) Use the LEFT or RIGHT ARROW to select #1 station if not already displayed, and
+ or – key to set manual flushing time.
3) To manually activate a program, press PRG key. Program letter (A, B, or C) will show
on screen. If a different program is needed, press PRG key until desired program is
displayed.
4) To stop MANUAL FLUSHING cycle press – key until time is reduced to zero.
5) Press RETURN/ENTER key to proceed to next programming function, or allow
controller to return to idle mode.
NOTE:
• Pressing + or – key when running in MANUAL FLUSH mode will modify FLUSH
TIME for that station.
• Pressing the button when a station is running in manual watering will stop irrigation
on the current station and advance to the next station.
• Pressing the button when a station is running in manual watering will stop the
irrigation on the current station and revert to the previous station.
Turn System Off
To turn off controller, press RETURN/ENTER key button until icon resembling water
spray and OFF is displayed on screen. To return controller to auto programming
mode, press RETURN/ENTER key. The controller will immediately return to auto
programming mode and will display time and battery life indicator.
NODE Quick Check
This circuit diagnostic procedure can quickly identify “shorts” commonly caused by
faulty solenoids or when bare common wire touches a bare station control wire. To
initiate NODE Quick Check procedure:
1) From Idle Mode, press and hold +, –, LEFT ARROW, and RIGHT ARROW keys.
2) Display will show all segments. Release keys.
3) Press + key to initiate NODE Quick Check test.
4) Controller will then activate flushing unit for 1 second to verify operation.