2
Starting up
If EasyLase USB II is powered using an external powersupply, use regulated DC powersupply only.
The device works with voltages from 8V to 24 V.
It is recommended to use powersupplies which are well immunized against power line transients
or to use power plugs with integrated EMI-filters.
For enhanced reliability during operation, the use of a high-quality USB2.0-cable (double shielded
with integrated EMI-filters) is suggested
Lowquality-cables can cause malfunction of hardware and software.
Each device comes with a CD-ROM, containing documentation, drivers and test software.
2.1
Handling instructions Boardversion (OEM-Version)
When the device is used as open board version (OEM), it should be taken into account, that the
device is sensitive object. Static discharge and other external influence can damage electronic
components on the board.
The device can also be damaged by applying external voltage to signal pins, by wrong connections
and other kind of manipulation. Watch for correct connection of signals and careful handling.
The manufacturer excludes liability in case of damages as result of unproper handling, wrong
signal connection and unspecified working conditions, unless it is verifiable that damage
existed when the product left factory.
Also any liability claims regarding damage caused by the use of this product will be rejected.
2.2
Step-by-step driver installation
Important!
Each device, which is connected to the USB-port of the PC for the first time, needs a driver
installation. Also an installation will be necessary, when the USB-port for connecting the device
will be changed (depends on operating system).
Using multiple devices, it is recommended to use the same port for the same device all times to
avoid driver reload.
When installing the first device, it is necessary to locate the driver files on the data media (disk, CD-
ROM). When installing additional devices, the option 'automatic installation' of the driver
installation wizard can be selected.
The driver can be installed directly from CD, but it is suggested to locate the driver files in a
directory of the harddisk.
Copy the file 'EasyLase.dll' into the directory, where the executable file of showsoftware is located.
If you want to remove the device drivers, deinstallation has to be done in the systemmanager.
Connect the device to the USB-port. When using external powersupply, switch it on.
The green LED 'Power' and the red LED 'Active' must be lighted.
Wait until the following message appears.
Do not disconnect the device and do not close/cancel any messages of your PC.
4
