KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
99
In the groove, adjust the mounted machines first for the same depth of the front and rear work
tools and then set the required depth of treatment and finally align in the longitudinal plane by
means of the central track rod and in the transverse plane
– by changing the length of vertical
brace-struts.
N o t e . The procedure for regulation of work tools of agricultural machines (implements), their
operating modes as well as their transfer into the transportation position are indicated in the
operating manuals for these machines and implements.
The drain line from the hydraulic motor shall be connected, via a hose with the internal diameter
of 20 mm, length of 3,200 mm (it is available in the SPTA kit), directly to the cover of the
hydraulic tank filter being the right-hand in the direction of tractor motion, avoiding the hydraulic
distributor.
In hooking up with implements equipped with hydraulic motors (for example, fan), their hydraulic
lines should be connected to the 2nd and 3rd pair of clutches of the tractor hydraulic system.
Connect the hydraulic motor line to the “Lowering” position. Perform shutdown of the hydraulic
motor by setting the handle of hydraulic distributor into the “Floating” position.
Fig. 27 Nameplate on
the rear wall of the fuel
tank
6.6.2 Tractor operation with ploughs
The depth of ploughing under the front and rear housings of the plough is set only by screws of
the front and rear mechanisms of carrier wheels of the plough.
In preparing the plough for long-term transportation, the length of central track rod decreases so
that the outermost point of the plough in the lifted state should not exceed the external height of
the tractor.
In hooking up with a mounted plough, in order to provide the floating mode, the pins of vertical
struts of the mounted implement shall be installed so that they should pass through lower holes
of outer and longitudinal grooves of internal pipes of vertical struts (open strut).In doing so,
dimension A (Fig.23) on the top and on the bottom shall not be more than 60 mm.
Clutches for connection of
hydraulic motor
Diagram of connection to quick lock couplings of
hydraulic system
lowering
lifting
Control unit handles
lifting
lifting
lifting
lowering
lowering
lowering
Содержание K-744R1
Страница 2: ...MTZ KIROVETS tractors K 744R1 K 744R2 K 744R3 K 744R4 2...
Страница 107: ...KIROVETS K 744R1 K 744R2 K 744R3 K 744R4 tractors 107 Driving shaft friction clutch I...
Страница 109: ...KIROVETS K 744R1 K 744R2 K 744R3 K 744R4 tractors 109 Driving shaft friction clutches II and III...
Страница 111: ...KIROVETS K 744R1 K 744R2 K 744R3 K 744R4 tractors 111 Driving shaft friction clutch IV...
