4.
Route 10ga red power wire from furnished wiring harness starting
at pre amp location. Route wire under rear seat on driver's side, over to
threshold and under carpet to the front of vehicle.
5.
Open hood.
6.
Drill a hole through the fire wall. Locate a spot low on the fire wall on
the driver’s side. You should always look to find a clear path. Drill a hole
from inside of the vehicle into engine compartment and insert grommet.
Firewall
Battery
Drill Hole
for Grommet
Note: To avoid any damage to parts inside engine compartment, drill
from inside of vehicle using a short bit.
7.
Route 10ga red power wire through grommet into the engine compart-
ment.
8.
Route 10ga red power wire through engine compartment safely away
from any moving or hot parts that could damage the wire.
9.
Cut 10ga red power wire to length, connect the supplied fuse holder
from the wire kit to the end of the wire.
Optional
- The EBC, or Electronic Bass Control, allows a remote bass
control to be adjusted from the driver's seat.
Setting Crossover
You should set the crossover to your own personal listening taste. The
crossover is adjustable to any frequency between 50Hz (counterclock-
wise) to 150Hz (clockwise). As a guideline, the goal is to create the illu-
sion of bass up front. The higher the crossover point the more “audibly
visible” your sub is going to be. Take your time and really listen to your
system, grab a soda and a few of your favorite tunes and have fun.
TROUBLESHOOTING TIPS IF AMP DOES NOT TURN ON
Check all connections at battery and that fuse is installed
Check speaker wire connections
Check ground
Check fuse on pre-amp
18.
Reinstall threshold trim. Locate and align holes in vehicle with pins on
trim; secure with the phillips head screws removed earlier.
19.
Mounting of enclosure: Pass lug holding spare tire into place through
the hole in enclosure and then through a lug hole (not through the center
hole) in the spare tire. Replace washer and secure all with wing nut. Zip
cover.
Wing Nut
Lug
2
5
