READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING
MOUNTING LOCATION:
The enclosure mounts in trunk of two or four
door Civic on passenger side.
TOOLS REQUIRED FOR INSTALLATION:
Powered Screwdriver
Wire Cutters
10mm Wrench
Terminal Crimpers
INSTALLATION:
Follow the steps below
1.
Place enclosure in trunk of vehicle, with woofer firing to the rear of the
vehicle on passenger side (do not mount yet).
2.
If externally amplified make speaker connections to the enclosure
from your amplifier; loosen terminal knobs (a 13-mm nut driver can be
used). Connect speaker wires from amplifier to enclosure, positive to the
red terminal knob and negative to the black terminal knob. Refer to step
20 for mounting directions
.
AMPLIFIED THUNDERFORM
Routing Power Wire; we recommend a connection directly to the
battery.
3.
Remove passenger side door threshold, pull up firmly but slowly. The
trim will remove easily. If the car is a four door then both the front and rear
For technical assistance call 1-800-CALL MTX.
These instructions are guidelines only and in no way are intended to
replace a professional installation. As always before screwing or drilling
check to make sure you will not damage any wires or hoses or cause
damage to the vehicle.
Warning:
Batteries normally produce explosive gases which can cause
Warning:
Warning:
personal injury. Therefore, do not allow flames, sparks or lighted
substances to come near the battery. When charging or working near a
battery, always shield your face and protect your eyes. Always provide
ventilation.
Conventional Wiring of Aftermarket Radio
_ _
+
20 Amp Fuse
Low Level Signal
Turn On Lead
20
A
20
A
G
N
D
RE
M
EB
C
RI
G
H
LE
FT
LE
FT
X-
O
VE
R
X-
O
VE
R
ST
AT
U
S
Optional EBC
(Electronic Bass Control)
1
6
