MTX RANGER-10, Руководство пользователя

Страница: 9 / 12

M T X . C O M
9
Step 12 - Attach the enclosure to the 90
°
angle bracket using the included ST6.3 self-tapping screws.
A
1
⁄
8
" drill bit should be used to pre drill holes in the enclosure. Be careful not to strip them when
tightening into the enclosure material. Do not use an impact driver for these screws.
Step 13 -Now that the enclosure is securely tightened in place, the power and signal wires need to
be connected to the battery and signal source.
• The Red wire should be connected directly to the battery’s positive terminal and fused with a
20A fuse.
• The Black wire should be directly connected to the battery’s negative terminal.
• If your vehicle is equipped with the Polaris
®
busbar kit, the Red and Black wires can be
connected to the busbar under the hood. The Red wire will still need to be fused.
• The Blue wire can be connected to the ACC / Key Turn On located on the busbar of any vehicle.
Step 14 - Connect the RCA inputs to the signal source of your choice
Step 15 - Turn the unit on and check to make sure everything works. Set the gain using the gain pot
that is attached to the orange/grey wires. Set the gain to the bass level desired.
Step 16 - The included EBC can be connected and mounted to a desired location to allow easy trim
adjustment of the bass level after the gain has been set.
Step 17 - Replace all the parts and screws that have been removed to return the RANGER back to its
completely assembled state.