GAS BURNER
3
Burner nozzle
Burner nozzle
Gas feed
controller
Gas feed
controller
Gas feed
controller
Ignition button
Ignition button
Ignition
button
or skin. In case of skin contact, rinse in plenty
of water. In case of eye contact, immediately
rinse your eyes in water and seek medical ad-
vice. If the cylinder is empty, put it in a safe
re. Do not
puncture or burn it.
IMPORTANT:
1) When the work is done, close the gas
feed control valve until tight.
2) When the burner is cooled, in order to
inactivate it, turn the gas cylinder anti-
clockwise relative to the burner body, and
then place the burner and the gas cylinder
separately. Pay attention to the warning
label on the gas cylinder.
GENERAL INFORMATION
Portable gas burner designed for general
purpose. Energy source for the burner is
a usual gas cylinder with ring holder. The
ame resistant
to wind and rain with temperature about
1300-1450 °C.
The burner is used as self-contained heat
energy source for a range of works. In gen-
eral, it is used for the following works:
- Melting and welding of glass and plastic
products, including plastic pipes, synthetic
cords, and ropes.
- For works in low-melt metals and alloys
(lead, tin, zinc, aluminium, gold, silver, etc.),
particularly for soldering and welding;
- For heating various items, for example, to
facilitate frozen-up threaded joints bending;
- To remove old paint;
re) when
the weather is damp or there is no dry
rewood.
- Make sure this cylinder complies with the
burner.
ed gas of
good quality to connect.
- Make sure the burner is on – gas feed
valve is tightened towards OFF position,
that is “-“ symbol is shown on the gas feed
controller.
1
2
3
HOW TO CONNECT THE BURNER TO THE GAS CYLINDER
ENG