MTS Systems Landmark 370 Series, Операция

Страница: 70 / 134

Running the Example HCF Test
70 Landmark™ Test System Operation
l
F Gain — 0
l
F2 Gain — 0
l
Proportional FF Gain — 0
l
FL Filter — Set to maximum positive value
4. Retain the Tuning user access level.
Leave the Operator Type selection set to Tuning because you will do more tuning once the
specimen is installed.
Install the Specimen
Installing the specimen consists of the following tasks:
1. “Power up the Pump and HPU” on page 70
2. “Position the Actuator Using Displacement Control” on page 71
3. “Zero Displacement” on page 73
4. “Clamp the Specimen in the Lower Grip” on page 74
5. “Position the Crosshead” on page 76
6. “Move the Specimen into the Upper Grip Using Displacement Control” on page 76
7. “Switch to Force Control” on page 77
8. “Clamp the Specimen in the Upper Grip” on page 77
9. “Check and Reset Meter History” on page 78
Power up the Pump and HPU
1. Correct any interlock conditions. If a limit has been exceeded, see “If Necessary, Recover
from a Tripped Force Limit” on page 107 or “If Necessary, Recover from a Tripped
Displacement Limit” on page 110
2. If necessary, reset the interlock.