Electrical Precautions:
∧
Please do not allow any metal part to short circuit the battery or any electronic part using inside the car kit.
∧
Never put batteries into fire.
∧
Use the recommended charger for the transmitter battery and battery for electronic speed control. Please follow
the charging instructions carefully. Please do not over charge the battery or choose the wrong charging mode. It
becomes dangerous that causes the explosion and lead to the fire. If battery becomes extremely hot during the
charging, please seek the advice from or get replacement from the corresponding battery supplier.
∧
Please unplug charger when not in use.
∧
When not using RC model, please always disconnect and remove the battery.
∧
Low battery may result in loss of control. Please stop running the car at once when you find its speed start to
slow down.
∧
After use the battery, the battery remains heat and please recharges it after the battery is cool down.
∧
Never use damaged wires that are dangerous and cause short circuits and may lead to the fire.
Other Equipment Needed (not included):
Radio transmitter & receiver
Battery for transmitter
Electronic speed control
Steering Servo
540 Type brushes or brushless motor
Pinion Gear (48pitch/64pitch)
190mm body shell
7.4V Nimh or Lipo Battery
Touring Car Tire set
Battery charger
Tools Needed (not included):
1.5mm, 2.0mm, 2.5mm allen wrench
5.0mm, 5.5mm, 7.0mm hex socket wrench
Modelers craft knife
Turnbuckle wrench
Calipers/Ruler
Camber gauge
Instant glue/Thread lock glue
Shock and Diff Oil
Thrust, Diff and Joint grease
Paint for body shell
Notes: All replacement parts can be found from
www.race-opt.com
and can be purchased from local
hobby shop. If any further information needed, please email to
.
2
