MTN Products Horizons Counter Top, Полное руководство

Страница: 7 / 22

Horizons® Counter Top Complete Manual
5
Programming The Horizon® Counter Top Cooler
Note: All programming is accomplished using the three buttons
located directly below the LCD display screen.
VERY IMPORTANT: After each change is made, the “Setup” button
must be pressed for programing to be accepted.
•
To access program mode press and hold the “Setup” button for 7 seconds.
•
After 7 seconds Time will display on the LCD. Use the “Up” or “Down” buttons to set
the correct time.
•
Press “Setup” button again and Date will display on the LCD. Use the “Up” or “Down”
buttons to set the correct date.
•
Press “Setup” button again and ES (energy saving) start time will display on the
LCD. Factory default time is 11:00 PM. Use the “up” or “Down” buttons to set the
correct start time.
IMPORTANT: To activate ES push orange button in. This button is located on the
rear of Horizon.
Note: It is not recommended to use this feature if the cooler is set in a facility that
operates 24 hours per day.
•
Press “Setup” button again and ES (energy saving) stop time will display on the
LCD. Factory default time is 6:00 AM. Use the “Up” or “Down” button to set time to
deactivate the ES mode.
•
Press “Setup” button again and Mute will display on LCD. Factory default is Mute
Off. Use the “Up” or “Down” key to set mute mode.
•
Press “Setup” button again and Accu-Temp will appear on the LCD. Factory default
is ACCU.TEMP On. It is recommended to be left in the On position. When either the
hot or cold water button is pressed the water pump comes on for one second and
recirculates the water in tubing back into the tank, pump than comes back on an and
will dispense either colder or hotter water. If Accu-Temp is set the off the
recirculation portion is shut off. . Use the “Up” or “Down” key to set Accu-Temp
mode.