Button Descriptions
•
Hot Water
- Press the Hot button (#3 below) and hold
for 1 second (the unlock indicator ring will light-up red--
#2 below.) Then press the Water Dispense button (#2)
to dispense hot water.
•
Cold Water
- Cold water is the default setting and the
unlock indicator ring will always be blue (#2) unless hot is
selected (then it will be red). If the unlock indicator ring is
red, press the cold water button (#4 below), then press
the Water Dispense button (#2). Otherwise, just press
the Water Dispense button.
•
When the water bottle is empty, the No Water indicator
light will flash (#1 below). Load a new bottle of water
and push the dispense button (#2) to continue
operation. The no water indicator light will turn off and
stop flashing.
•
If the Cold Water light (#4) is flashing, this means the
compressor has shut down due to a low water/no water
situation for more than 10 minutes.
•
Load a new bottle of water and push the dispense
button (#2) to resume normal operation. The no
water indicator light (#1) will turn off. The cold water
light will stop flashing when the water reaches normal
operating level.
Bottle Loading
Set-Up Instructions
•
Remove the cooler from the shipping box and verify
that there is no damage to cooler.
•
Ensure cooler is located on a level floor out of direct
sunlight.
•
Wipe water bottle with a damp cloth and remove
label from the No Spill cap. Insert dip tube into bottle.
Continued on back.
