6
QSG 900LR-1.7
Oct 2010
6
Linking your transmitter and receiver units
You must reset the transmitter unit to factory defaults (to disable encryption)
before linking the transmitter and receiver units. For more information, see
the WIO-900LT Transmitter Quick Start Guide.
NOTE: You must complete the linking process in 60 seconds.
To link the transmitter and receiver units:
1. Press and hold down the RSSI Pushbutton on the receiver.
2. Power on the receiver while holding down the RSSI Pushbutton
3. Release the RSSI Pushbutton as soon as the Receiver LEDS flash (within
5 seconds of powering the receiver).
4. The receiver will flash all LEDs for a maximum 60 seconds while it tries to
link to the transmitter.
5. Power on the transmitter. The transmitter sends a special “Link” message
to allow the receiver to recognise the transmitter.
6. When the units link, the receiver lights all LEDs for 2 seconds before
returning to normal operation.
NOTE:
If the receiver LEDs continue flashing within the 60 seconds, the
units are not linked and you should retry the linking process by powering the
transmitter off and on again. If you exceed the 60 seconds, you must restart
the linking process from step 1.
You can now bench test your configuration before deploying.
7
Safety information
Thank you for selecting the WIO-900LR receiver for your telemetry needs.
We trust it will give you many years of valuable service. To ensure your
WIO-900LR receiver enjoys a long life, double-check ALL your connections
with the user’s manual before powering on the unit.
WARNING: Incorrect termination of supply wires may cause internal damage
and will void warranty.
Exposure to RF energy is an important safety consideration. The FCC
has adopted a safety standard for human exposure to radio frequency
electromagnetic energy emitted by FCC regulated equipment as a result of
its actions in Docket 93-62 and OET Bulletin 65 Edition 97-01.
FCC Notice when used in USA: WIO-900LR Wireless I/O Module
Part
Additional information
15
This device has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part15 of the FCC rules (Code of
Federal Regulations 47CFR Part 15). Operation is subject to the condition
that this device does not cause harmful interference.
90
This device has been type accepted for operation by the FCC in
accordance with Part90 of the FCC rules (47CFR Part 90). See the
label on the unit for the specific FCC ID and any other certification
designations.