FREEDOM UNIVERSAL 2.0
6
FREEDOM AXIS
Angled risers should be mounted on a
horizontal surface.
The short, through-hole mount is recommended for
angled surfaces (35 degrees up to vertical).
Recommended base spacing to accommodate most tablet
models is 12 inches on center (minimum).
Hole Diameter
1.65” (min)
1.75” (max)
Underside of fixture
Locking nut
Tightening tool
Install components so the mounted device(s) will be able
to fully rotate without interfering with the fixture, walls, or
other positions. If the device will be powered, make sure
the SmartCable will not interfere with fixture, wall, or other
positions and will rotate without interference.
Installing System Components
Before you begin: Review mounting recommendations and the installation steps below to help determine the desired mounting
location of all components..
Secure base to fixture using one of the three options described below:
Option A:
Locking nut (through-hole bases
only)
A. Drill hole through the fixture top.
B. Insert base into hole; then rotate to
desired orientation (direction that puck and
mounted device will face).
C. Thread locking nut onto base with teeth
on nut facing up.
D. Tighten locking nut as tight as possible
using the tightening tool (base should not
spin).
1
C
D
B
A
