Instructions
Basic Set Up
Before the bridge can be used, the piers must be attached to the bridge. Using the
pier mounting screws provided, mount the 3 piers to the bridge. One on each end
and one in the center. Make sure that the pier with the light control board (refer to
figure 2) is placed at the wired end of the bridge. Insert the wire through the hole
in the pier as shown in figure 1.
Plug the wire into the control board as shown in figure 2. Finish mounting the
pier to the bridge as shown in figure 1. Route the power supply wires from the
control board through the wire notch at the base of the pier (see figure 3) and
connect the wires to a 14 to 20 volt power supply.
Figure 1
Figure 2
Figure 3
Wire Notch
Red - AC
Black - ACG
The Steel Arch Bridge is comprised of four (4) major components, the bridge
itself, and three piers. Also included are 12 pier mounting screws and 3 Lionel
restle Pier Adapters.
The bridge also features a beacon which flashes when connected to a 14-20 volt
power supply.
®
T
