Instructions
To replace the interior light bulbs, follow these steps.
1) To remove the shell from chassis remove the four screws
located underneath the trucks.
2) With the four screws removed, lower the chassis from the
shell, take care not to pull the wires out.
3) To be able to separate the interior from the shell you need
to remove the step platform from both ends. In order to do
this you need to loosen the end frames from the step
platform. You must do this carefully so that you don't break
them. Grasp the end frame by the bottom and pivot outwards
5
With the step platforms removed you can then lower the
interior down from the shell (to completely remove the body
from the interior, go to step 6).
5) You can replace the bulbs by pushing the socket up from
the bulb holder and pull the bulb from its socket. Replace
with a new one, and reverse the steps to reassemble the
caboose. To replace the two red LED lights at the ends of the
caboose, follow steps 1- 4, 6 and 7.
6) Turn the caboose upside down and unplug the red LED's
from underneath the interior.
7) There will be two spots of hot glue holding the LEDs in
place. Use a screw driver to loosen the wires from the spots
of glue. Pull the LEDs back towards the inside of the shell to
remove them. Replace the LEDs with a new set and use hot
glue to put the wires back in place. Plug the wires back into
the connector under the interior. Reassemble.
NOTE: When reassembling, the end posts of the shell must
pass through the corresponding holes in the interior.
°. You can then remove the step platforms.
4)
STEP
6
STEP
4
STEP
3
Grasp
Here
END FRAME
STEP
PLATFORM
STEP
5
Remove these
four screws
STEP
1
STEP
2
STEP
7
End Posts of
the Shell
Wires Should
Be Tucked
Behind These
Clips Upon
Re-assembly
