background image

10

Operation

5

Determine The Starting System

Using Your Lawn Mower

Be sure lawn is clear of stones, sticks, wire, or
other objects which could damage lawn mower
or engine. Such objects could be accidently
thrown by the mower in any direction and cause
serious injury to the operator, others, or the
equipment.

WARNING:

The operation of any

Add fuel before starting the engine, you must 
determine the type of starting system that is on 
your engine. Your engine will have one of the  
following types:

 

Auto-Choke System

: This features an 

automatic choke that does not have a 
manual choke or primer.

 

Primer System

                               : This features a primer on 
the engine.

 

Electric Start System

                                            : This features an 
electric start switch on the handle. 

To start your engine, follow the instructions for 
your type of starting system.

NOTE: 

Equipment may have remote controls. 

See the equipment manual for location and 
operation of remote controls.

NOTE: 

Only BBC equipped units can be  

startedor stopped blade seperately after 
starting the engine.

Starting the Engine

Starting the Blade(BBC Equipped)

Stopping the Blade(BBC Equipped)

WARNING: 

Always keep hands 

and feet clear of equipment 
moving parts. Do not use a 

2.

Move the throttle control lever to start 
position.

3.

Standing behind the mower, squeeze and
hold the blade control against upper 
handle. (

If equipped BBC or electric start

system, skip to step 4. 

Figure 5-1

4.

Pull the recoil starter lightly until 
resistance is felt, then pull rapidly to 
overcome compression, prevent kickback,
and start the engine. Repeat if necessary. 
See Figure 5-1. 

5.

Insert plastic Electric Starter Push Key into 
starter housing located on the right side of
upper handle until it snaps in place.

6.

Push the electric starter push key to start 
the engine. 

IMPORTANT: 

Do not allow the recoil starter

to snap back against the rope guide. 

1. 

Push primer three times. Wait about two 
seconds between each push. See Figure 
5-1. In temperature below 50°F, 
times. After the engine is warmed up, one 
prime may be needed for all temperatures. 
If engine does not start, it may be 
necessary to re-prime the engine. (

Only 

for primer equipped engine. If no 
primer, skip ahead to step2.

)

 

Below two steps only for the electric 
start units. 

NOTE: 

Electric starter is equipped with an 

internal circuit breaker. If unit fails to start 
when starter button is depressed, wait one 
minute for breaker to reset, then attempt 
to start again.

Stopping Engine

1.

Rlease blade control.
Move the throttle control lever to stop 
position(

BBC equipped unit only

).

1.

After starting the engine,push the upper 
handle downward around 10cm to incline
the deck up toward to make sure the 
blades are away from grass. See 
Figure 5-2.

2.

Squeeze and hold the blade control 
against upper handle, push BBC lever to 
the end until heard a sound then release 
it.

1.

Release blade control level.

3.

2.

Remove Electric Starter Push Key if mower
is to be left unattended, stored, or serviced

(Electric Start units only)

.

 

To remove key, grasp the key’s top push 
button and pull it straight up and out. 
Keep key in a safe place out of the reach 
of children. 

Using Grass Catcher 

Attach grass catcher following instructions
in the “Assembly & Set-Up” section. Grass 
clippings will automatically collect in grass 
catcher as you run mower. Operate mower
till grass catcher is full.

1.

Stop the engine. Make sure that the unit 
has come to a complete stop.

2.

Lift discharge door and pull grass catcher
up and away from the mower to remove 
the grass catcher. Dispose of the grass 
clippings and reinstall the grass catcher 
when complete.

3.

WARNING:

If you strike a foreign

object, stop the engine. Remove 
wire from the spark plug, 
thoroughly inspect mower for any 
damage, and repair damage before
restarting and operating. Extensive
vibration of mower during 
operation is an indication of 
damage. The unit should be 
promptly inspected and repaired.

Using as Mulcher

For mulching grass, remove the grass catcher 
and allow the rear discharge door to close the 

do not cut wet grass. If the grass has been 
allowed to grow in excess of four inches, 
mulching is not recommended. Use the grass 
catcher to bag clippings instead.

3

1

6

3

4

5

lawn mower can result in foreign
objects being thrown into the 
eyes, which can damage your 
eyes severely. Always wear safety
glasses while operating the 
mower, or while perfoming any 
adjustments or repairs on it.

You can use the grass catcher to collect clippings
while you are operating the mower.

Figure 5-2

10cm

2

Содержание Procut 700 series

















Отзывы: