2
SECTION 1: TO THE OWNER
The Model 604 TracPac
™
is designed for use on FastAttach
™
Compatible Lawn Tractors and Garden Tractors
only.
NOTE:
References to LEFT and RIGHT indicate the left and right sides of the tractor when facing forward in
the operator’s position. Reference to the FRONT indicates the grille end; to the REAR the drawbar end.
SECTION 2: CONTENTS OF CARTON
Before beginning installation, remove all parts from the carton to make sure everything is present. Carton
contents are listed below and shown in Figure 1. Hardware part number are shown in parentheses.
One Plastic Tool Box
One Bracket Assembly w/ Clevis Pin (711-0309A)
& Hairpin Clip (714-0117) in place.
Figure 1
SECTION 3: ASSEMBLY
Warning:
Before beginning installation, place the tractor on a firm and level surface. Place the
PTO in the disengaged (OFF) position, stop the tractor engine and set the parking brake.
MOUNTING THE BRACKET ASSEMBLY & TOOL BOX
1.
Pivot the seat of the tractor seat forward.
2.
Remove the hairpin clip and clevis pin from the hole in the rear of the bracket assembly.
3.
Position the hooked ends of the bracket assembly to the outside of the hitch plate and over the shoulder
bolts. Refer to Figure 2.
4.
Reinsert the clevis pin through the aligned holes provided in both the bracket assembly and the hitch
plate. Affix with the hairpin clip. Refer to Figure 2.
IMPORTANT:
There are two holes found in the clevis pin. Be certain to insert the hairpin clip in the UPPER
hole to properly secure the bracket assembly to the hitch plate
5.
Slide the plastic tool box down onto the bracket assembly so that the opening of the box is facing the rear
of the tractor.
Plastic Tool Box
Bracket Assembly
Clevis Pin
Hairpin Clip
