MTD Mulch 'N Catch 35M, Руководство пользователя, Страница: 4 / 8

2
Rover Mowers Limited MULCH 'N CATCH
TM
2.3 Installing the Mulch Plug for
Models 50m, 51m, 60m, 61m & 80m
(
Figure 2):
1. Stop the engine.
2. Lift the rear flap of the mower.
3. Remove the grass catcher or deflector (if
fitted).
4. Insert the long right hand side of the mulch
plug first, into the rear of the mower.
5. Guide the mulch plug in and seat down on
the rear axle retainer.
6. Close the rear flap.
Figure 2 - Installing the Mulch Plug -
50m, 51m, 60m, 61m, & 80m
2.6 Vari-Tilt Conbar System ( Figure.
3):
The Rover Vari-Tilt System (Patent Pending) is
fitted to provide improved performance.
Generally it is recommended that the Conbar is
at it’s longest length for Mulch Mowing and it’s
shortest for Catch Mowing. These
recommendations may not suit your grass
conditions in which case you should adjust to
suit. The Conbar at it’s longest length also
provides a greater maximum height of cut.
2.7 Vari-Tilt Conbar Adjustment -
Mulching (
Figure. 3):
1. Stop the engine.
2. Move the Cut Height Lever to the high cut
position (1).
3. Loosen the Conbar Locking Knob (2).
4. Apply pressure to the top of the handle bars
to tilt the mower back so that the gap in the
Conbar arms is at its widest.
5. Maintain pressure on the handle bars and
tighten the Conbar Locking Knob.
2.8 Vari-Tilt Conbar Adjustment -
Catching (
Figure. 3):
1. Stop the engine.
2. Move the Cut Height Lever to the high cut
position (1).
3. Loosen the Conbar Locking Knob (2).
4. Pull the handle bar towards the front of the
mower to level the mower so that the gap in
the Conbar is at its narrowest.
5. Maintain forward pressure on the handle bars
and tighten the Conbar Locking Knob.
2.4 Removing the Mulch Plug for
Models 35m and 75m (
Figure 1):
1. Stop the engine.
2. Lift the rear flap.
3. Grasp the handle and, with a firm jolt, lift
the mulch plug up and away from the mower.
4. Guide the mulch plug out by rotating the
shorter left hand side to the right and then
guiding the longer right hand section until
clear of the mower.
2.5 Removing the Mulch Plug for
Models 50m, 51m, 60m, 61m & 80m
(
Figure 2):
1. Stop the engine.
2. Lift the rear flap of the mower.
3. Grasp the handle and lift the mulch plug up
and away from the mower.
4. Guide the mulch plug out by rotating the
shorter left hand side to the right and then
guiding the longer right hand section until
clear of the mower. Figure 3 - Conbar Adjustment - 35m, 75m,
50m, 51m, 60m, 61m, & 80m
1
2