MTD 6FE, Руководство оператора

Страница: 13 / 28

13
SECTION 5: MAKING ADJUSTMENTS
WARNING:
Never attempt to make any
adjustments while the engine is running,
except where specified in operator’s manual.
Shift Rod Adjustment
If the full range of speeds (forward and reverse) cannot
be achieved, refer to the figures to the right and adjust
the shift rod as follows:
1. Place the shift lever in the fastest forward speed
position. Remove the hairpin clip which secures the
ferrule to the shift lever.
2. Rotate the shift arm clockwise as far as it will go.
3. Thread the ferrule up or down the shift rod until it
aligns with the hole in the shift lever behind the
handle panel. Resecure the ferrule with the hairpin
clip removed earlier.
Tire Pressure
• Before operating, check tire pressure and reduce
pressure to between 15 psi and 20 psi.
NOTE:
If the tire pressure is not equal in both tires,
the unit may pull to one side or the other.
Chute Assembly
The distance snow is thrown can be adjusted by
changing the angle of the chute assembly. To do so,
stop the engine by removing the ignition key and loosen
the plastic wing knob found on the left side of the chute
assembly. Pivot the chute upward or downward before
re-tightening the wing knob. See Figure 3.
Figure 3
1
2
3