9
Figure 10
•
When correct adjustment is reached, tighten the
hex nut against the cable to lock it in position.
Attaching the Chute Assembly
(Hardware B)
•
Place chute assembly over chute opening, with the
opening in the chute assembly facing the front of
the unit.
•
Place chute flange keepers beneath lip of chute
assembly, flat side down.
•
Insert hex bolt up through chute flange keeper and
chute assembly as shown in Figure 11. Secure with
hex lock nut.
•
After assembling all three chute flange keepers,
tighten all nuts and bolts securely, then back off 1/4
turn to allow easier movement.
Figure 11
Attaching The Chute Directional Control
(Hardware C)
•
Loosen the two hex nuts which secure the lower
chute directional control support bracket to the
snow thrower housing. See Figure 12
Figure 12
•
Place one flat washer over the end of the chute
directional control, then insert the end of the chute
directional control into the hole in the plastic
bushing in the chute bracket. See Figure 13. Place
the second flat washer on the chute directional
control, and secure with hairpin clip.
Figure 13
•
Thread one hex nut onto the eyebolt on the chute
directional control assembly until there is at least
two inches of thread showing between the nut and
the head of the eyebolt. See Figure 14.
Figure 14
•
Place the eyebolt into the hole located half way up
the left handle. Secure with cupped washer
(cupped side against the handle, see inset) see
Figure 14.
“Z”
Hex
Nut
Cable is
Straight
Chute
Assembly
Hex Bolt
Hex Lock Nut
Chute Flange
Keeper
Carriage Bolts
Hex Lock Nuts
Chute
Directional
Control
Bracket
Hairpin Clip
Chute Directional
Control Bracket
Flat Washer
Chute Directional
Control
Cup
Side
Crown
Side
Left
Handle
Hex Nut
2” of
Threads
Cupped
Washer
Eyebolt
Hex Nut
