Assembly & Installation
4
8
Mount Assembly on Tractor
Install mounting assembly on tractor as follows:
Note:
Remove the rear bumper if equipped.
1.
Slide the mounting bracket assembly along the frame rails
of the tractor until the hooks in the mounting brackets
align under the shoulder bolts on your tractor, as shown in
Figure 4-2.
Figure 4-2
2.
Secure the mounting bracket assembly to the tractor using
two 911-0310 clevis pins and 914-04023 cotter pins from
hardware pack 689-00320. See Figure 4-3.
Figure 4-3
Note:
Tighten all of the hardware on the mounting
assembly at this time.
NOTE:
References to left, right, front and rear of the tractor are
from the operator’s position, unless otherwise stated.
•
Before assembly, place the tractor on a firm, level surface,
disengage the PTO, stop the tractor engine and set the
parking brake.
•
For convenience, pivot the seat forward and leave it in
that position until the grass collector is fully mounted and
assembled.
Assemble Mounting Brackets
To assemble the bagger mounting assembly, locate the
mounting assembly parts, as shown in Figure 4-1 in the previous
section, and follow these steps:
1.
Attach the two hitch side brackets to the rear attachment
bracket using four 710-0276 carriage bolts and 712-04063
flange lock nuts from hardware pack 689-00320. See
Figure 4-1.
Figure 4-1
Note:
When assembling this mounting assembly, it is best to
not fully tighten the bracket at this time. This will facilitate the
mounting process in later steps, which will then require fully
tightening this mounting assembly.
Содержание 19C70020OEM
Страница 16: ...Notes 16...
Страница 17: ...17 Notes...
