8
•
Remove bag from rim of the discharge opening.
Refer to Figure 3.
•
Twist the two buttons on the back of the bag to
unlock and empty contents. See Figure 7.
•
Hold bag handle and clip while emptying contents.
•
Compress bag opening and fold inner flap over the
opening. Fold outer flap over the inner flap and
insert buttons on the bag through metal outlets.
•
Twist buttons to lock the bag.
To Remove Blower Chute
(If equipped)
•
Grasp blower chute with one hand and with the
other, pull the lock rod on the mounting bracket
toward engine to release. Refer to Figure 5.
•
Remove blower chute from rim of the discharge
opening.
Using the Chipper Shredder Vacuum
Place both hands on top of the upper handle to push
unit over yard waste. Yard waste such as leaves and
pine needles can be vacuumed up through the nozzle
for shredding. After material has been shredded by the
flail blades on the impeller assembly, it will be
discharged into catcher bag or through blower chute.
Do not attempt to shred or chip any material other than
vegetation found in a normal yard (i.e. branches,
leaves, twigs, etc.) Avoid fibrous plants such as tomato
vines until they are thoroughly dried out. Materials such
as stalks or heavy branches up to 1-1/2” in diameter
may be fed into the chipper chute.
IMPORTANT:
The flail screen is located inside the
housing in the discharge area. If the flail screen
becomes clogged, remove and clean as instructed in
the Maintenance section on page 9. For best
performance, it is also important to keep the chipper
blade sharp.
WARNING:
Do not at any time make any
adjustments without first stopping the
engine and disconnecting the spark plug
wire.
Nozzle Height Adjustment
The nozzle can be adjusted by moving the height
adjustment lever to one of five positions, ranging from
5/8” to 4 1/8” ground clearance. Raise the nozzle height
to vacuum a thick layer of leaves or to operate with the
blower chute. Lower the nozzle height for smoother
surfaces. See Figure 8.
Figure 8
SECTION 5: MAINTAINING YOUR CHIPPER SHREDDER VACUUM
Lubrication
Wheels:
Lubricate each wheel shoulder screw once a
season with light oil.
Nozzle height adjustment levers:
Lubricate the pivot
points of the nozzle height adjustment levers once a
season with light oil.
Engine:
Follow the separate engine manual packed
with you unit for lubrication instructions.
Maintenance
Engine
Some general recommendations for good engine
performance are listed below. Refer to the separate
engine manual for further details and instructions.
•
Check
engine oil level
before each use as
instructed in the engine manual. Read and follow
instructions carefully.
•
Clean
air cleaner
every 25 hours under normal
conditions or once a season. Clean every few hours
under extremely dusty conditions. To service the air
cleaner, refer to the engine manual.
•
Clean
spark plug
and reset the gap once a
season. Check engine manual for correct plug type
and gap specifications.
Nozzle Height
Adjustment
Lever
Nozzle
WARNING:
Always stop engine and
disconnect spark plug wire before cleaning,
lubricating or doing any kind of maintenance on
your machine.
