8
(H)
(G)
(I)
G. Screw the control panel onto the spa, fasten the ring to the pipe adaptor.
Precautions:
1. When using the spa tub outside, air pipe can not be taken off. Do not use the spa
tub in rains as air pump will not working properly.
2. The two O-ring part on the air pipe is important to get the spa tub working properly.
Lost of the O-rings could cause air pump rusted or not working properly. Missing of
the O-rings also affects bubbling function.
H. Connect the pin plugs. Make sure that plugs are properly matched together,
screw a cap, and then you’ll see yellow light on control panel, no bent or wet for the
pin inside male connector which will cause failure connection.
I. Fill the Spa
Fill the spa with water from your garden hose to approximately 2-3cm, again, push the
bottom edges of the Liner tight to the Skirt to remove any wrinkles in the Liner. Continue
filling until it reaches the area between two water lines printed inside the Spa wall.
WARNING:
1. FILL IN WATER CAREFULLY ESPECIALLY FOR THE FIRST TIME OF USE. WATER
LEVEL MUST REACH THE MINIMUM WATER LINE BUT NOT EXCEED THE MAXIMUM
WATER LINE, OTHERWISE IT MAY CAUSE PUMP FAILURE.
2. PLEASE AVOID WATER SPILLAGE WHICH WILL CAUSE DAMAGE TO THE ELECTRIC
PARTS.
Warning:
to avoid function failure and damage to the control system, please do not operate until spa is illed
with water to the minimum water mark.
J. Place Spa Cover on the spa. Screw Safety Clasps directly into Corner Beams, using locking straps to locate
Safety Clasp position.
NOTE:
Lock up spa cover after each use.
Meijer.com
