MusicOne 24 User Guide
Page | 5 © Cambron Software 2015
Assembling the Solid Base Stand (Optional if supplied with Tripod Stand)
Attach the “top hat” to the semi-circular base using the 2 coach bolts, washers and wing nuts. The
wing nuts and washers fit into the recesses in the bottom of the base. Slide the top hat into a central
position on the bolts and tighten them. Tighten down the bolts so that the square “shoulder” of the
bolt is seated into the hole on the base. The wing nuts can be tightened using a pair of piers, if
necessary, for a permanent installation, use the 2 hex nuts that are supplied. Insert the pole and
tighten the Tommy bolt. DO NOT over-tighten the Tommy bolt.
Assembling the MusicOne 24
Step 1
Remove the fold-out stand on the rear of the PC.
Step 2
Separate the two parts of the Quick Release mount and attach
the part with the large round metal boss to the 4 VESA screw
holes (used to attach the fold-out stand).
Use the countersunk
Allen screws supplied.
Make sure the small round boss on the
plate is towards the bottom of the PC. Line up the holes
carefully. Don’t fully tighten the bolts until you have each bolt
in place.
STEP 3
Fix the other half of the Quick Release mount to the VESA Pole
mount. Using 4 x 10mm bolts supplied with the VESA pole mount.
It is very important you use the correct screws in each
position. Tighten the screws firmly but do not over-tighten
them.
Do not to use longer screws to attach the Plate to the
monitor. They may damage the circuit board in monitor
.
