4-16
Chapter 4
Re-Call VGA BIOS at S3 Resuming
Selecting
Enabled
allows BIOS to call VGA BIOS to initialize the VGA card
when system wakes up (resumes) from S3 sleep state. The system resume time
is shortened when you disable the function, but system will need an AGP
driver to initialize the VGA card. Therefore, if the AGP driver of the card does
not support the initialization feature, the display may work abnormally or not
function after resuming from S3.
Power Management/APM
Setting to
Enabled
will activate an Advanced Power Management (APM)
device to enhance Max Saving mode and stop CPU internal clock. Settings:
Disabled
,
Enabled
.
Suspend Time Out (Minute)
After the selected period of system inactivity, all devices except the CPU shut
off. Settings:
Disabled, 1, 2, 4, 8, 10, 20, 30, 40, 50, 60.
Power Button Function
This feature sets the function of the power button. Settings are:
On/Off
The power button functions as normal power off button.
Suspend
When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Restore on AC/Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Power Off
Leaves the computer in the power off state.
Power On
Leaves the computer in the power on state.
Last State
Restores the system to the previous status before power
failure or interrupt occurred.
Set Monitor Events
Press <Enter> and the following submenu appears.
