2-18
M S-96C4 Server Board
CompactFlash Card Slot: CF1 (Optional)
This CompactFlash slot shares one channel of the IDE controller (CF => Master; IDE
=> Slave). You can install one CompactFlash typeI / type II device.
Important
* The CF1 slot and the IDE1 connector shares and uses the same channel. CF1
and IDE1 can support up to 2 IDE devices without CF device or 1 IDE device
with 1 CF device.
* If you install two IDE devices, you must configure the second drive to Slave
mode by setting its jumper. Refer to the hard disk documentation supplied by
hard disk vendors for jumper setting instructions.
* If you install one IDE device with ATA100 IDE cable and one CF device, you
must configure the CF device to Master mode by setting jumper J6. CF only
supports
Master
mode by using
ATA100
IDE cable. CF only supports
Slave
mode by using
ATA33
IDE cable.
CF Mode Jumper: J6
This jumper is used to select Master/Slave mode of the CF device.
CF Voltage Jumper: J4
This jumper is used to select the operating voltage of the CF device.
CF1
Master
Slave
J6
1
1
3
1
3
VCC3
VCC5
J4
1
1
3
1
3
PDF created with pdfFactory Pro trial version
www.pdffactory.com
Содержание 945GC Network
