MshOt MG-100, Руководство пользователя

Страница: 10 / 11

4
Ⅲ
. Operation
1 2
a b
Figure 1
1.
Function description of control box
panel (Fig. 1, Fig. 2)
①
Visible light wavelength band numerical
display position
②
UV light wavelength band numerical display
position
a Visible light adjustment knob
b UV adjustment knob
c Main power switch
2.
Use steps of light source (Fig. 2,3,4)
2.1 First, as shown in Figure 2, press the key C
of the main switch, and then the B / G digital
display and UV digital display position in the
display screen will display three horizontal
lines respectively.
Then, as shown in Fig. 3, after pressing
the a key, the brightness of the B / G band light
source is adjusted by rotating the a key, and the
B / G digital display range is 0-100.
After pressing the B key, the brightness of
UV band light source is adjusted by rotating B
key. The range of UV digital display is 0-100.
2.2 When B / G or UV are not used, press a or
B again, the corresponding light source will be
turned off, and the display screen will return to
three horizontal lines. Because the power
control box has memory function, if you need
to use it, press a key or B key again.
Note: Key A and key B can be controlled
separately.
Note:The A and B keys can be controlled
separately.
2.3 Put the light source on the microscope,
observe the visual field, adjust the light source
field mirror according to different microscope,
as shown in Figure 4 finger position.
★
This product provides three bands of LED
light source, corresponding to UV 350 ~
385nm, B 430 ~ 480nm, G 500 ~ 550nm.
★ 按下总开关
c
键后，直接旋转
a/b
键是无
Figure 4
Figure 3
Figure 2
c
a b