Eco Trolley Manual revision 01/10
8
3.6 STOP CONTROLS
The Exhauster stop controls are:
•
main power cut-out by Main Switch (to set unit out of service located on control panel installed by the
Customer);
•
Main power cut-out by the disconnection of the power supply plug;
•
Button knife switch incorporated in
power control panel
that, when activated, cuts power to both
auxiliary and power circuits;
•
Controlled stop due to opening of the run enable auxiliary contact (e.g. suction mouthpiece Open /
Closed).
3.7 SAFE WORKING PROCEDURES
The Exhauster design features aim at eliminating all risks connected to its use.
The residual risks involved in operating mode are:
•
risks connected with the use of pneumatic energy;
•
risks connected with the use of electric energy;
•
risks of possible contact with product removed by suction;
•
Foot squeezing risk during handling.
To limit the consequences of such dangers as much as possible, it is important to comply with the following
rules:
•
Ensure that air supply pressure is available and set to specified value:
max 10 bar
s;
•
Do not start the Exhauster before checking the correct installation and parameters set at operator
panel; this can be done by running a cycle with no product to be taken in by exhauster;
•
Wear the personal protection gear suitable for the product in use;
•
Wear clothes with close-fitting sleeves;
•
Wear safety shoes.
3. 8 RESIDUAL RISKS
During the normal suction cycle and during maintenance, the Operators can run some residual risks that
can not be completely avoided, due to the type of operation being performed, such as danger of
electrocution and the noise.
3.9 NAMEPLATES
Table 3. 9A - Types of Nameplates
Nameplates on the Exhauster fig.3.9.A
Nameplate
“A” Nameplate
“B” Nameplate
“C”
Via R. Morandi, 93 - 40060 TO SCAN ELLA
BO LO GN A ITALY
Tel. 0542-673488 Fax 0542-672065
MO D.
KW
A
MASSA
Kg
VO LTS
Hz
M /h
3
Mbar
MATRICO LA N .
MESE
AN N O
CO STRUZ IO N E
200
Nameplate “D”
COCK
DRAIN
CONDENSATE
THE MACHINE WAS
DESIGNED TO
REMOVE DUST
DERIVING FROM SANDING
PRIMER,
FILLER/SURFACER AND
NOTHING ELSE
Nameplate
“E”
Nameplate
“F”
1
2