18
Tool applications:
•
Belt-Sander :
To grind plain surfaces
Safety instructions for belt-sanders
Belt mounting dangers:
•
Correct belt mounting is necessary to prevent injury from loosen belts.
•
Do not use chipped or cracked sanding belts
•
Use only belts fitting the machine easily. If you need more force than usual to install the
belt the size could be differ from the requirement.
•
Before sanding, test beltl by briefly running tool at full throttle. Be sure to use a barrier
(such as under a heavy working table) to stop any possible loosen belts.
•
A cracked sanding belt will cause serious hurts !
•
Regularly check the speed of the device by a tachometer to make sure the speed has
not been exceeded and is conform with the abrasive belts you use. The approvable
speed is mentioned down on the data sheet which comes with the belts.
•
Never use a belt marked with a speed lower than this tool !
•
Do not wear jeweled or loose clothing and avoid long hair.
•
Choking can happen if neckwear is not kept away from tool and accessories !
•
Avoid direct contact with accessories during and after use. Safety gloves will reduce the
risk of cuts or burns.
•
Use only proper accessories retainers (refer to parts list).
•
Use only sanding belts with the correct diameter, dimension and approvable speed
according to the technical data of this tool.
•
This unit has been developed as belt sander and must only used for this function. Any
misuse could occur serious health damage.
Dangers in use:
•
Do not lay down the device before all the rotary parts stopped
•
Do not keep the air tool running while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up. The operator can control torque
reactions or kickback forces, if proper precautions are taken
•
Never place your hand near the rotating accessory. Accessory may kickback over your
hand.
