MSE Audio Rockustics CHERRY BOMB, Руководство пользователя

Страница: 3 / 4

What’s Included
Cherry Bomb - 1
Wire Nuts - 2
Hex Key - 1
Wiring Diagram
The CB5 speakers run in an 4 ohm direct mode.
The speaker comes with hard wire leads.
See the figures below for a typical 4 Ohm wiring
configurations.
Speaker Installation
Rockustics recommends using either 14 gauge or 16 gauge direct-burial wire. It is best to lay out the wire to each of the
intended speaker locations before installing the speakers.
~12”
~14”
2. Digging
Dig a hole sufficient to bury
the speaker(s) to the correct
depth (noted above) and to also
accommodate 4-6” of gravel or
crushed rock under the speaker
housing.
HOUSE
PATIO
AMP
1. Layout Design
Determine the layout of your
system. Place each speaker
in the general location it will
be installed. Also place your
amplifier where it will be
installed.
3. 4 Ohm Wiring
For 4 ohm operation, locate
the set of wires. This will be a
red and black wire. Using the
supplied wire nuts, connect the
positive lead from the amplier
to the red wire and connect the
negative lead from the amplier
to the black wire.
8 Ohm Wiring Diagram
(Speakers Wired in Parallel)
Audio
Source
Amplifier must be able to handle a 4 Ohm load for this
configuration
4 Ohm Wiring Diagram
4. Connecting to Amp
Wire the Cherry Bomb speaker
to your amp. (Read your amp’s
instructions on how to properly
connect a speaker to your amp).