MSD SECTOR Image 2400, Инструкция по эксплуатации инструмента

Страница: 35 / 56

Quick Start 35
Figure 5:7 SECTOR Imager demonstration plate in the single plate adaptor
NOTE: If the SECTOR Imager is unable to read the barcode on the demonstration plate (or if no barcode label is present), the
plate will be skipped and ejected from the instrument. Please contact MSD
Scientific and Technical Support for
assistance.
5.3 Run
When the camera reaches proper operating temperature, the Instrument Log (click Show Log in the Status window) will indicate that
the temperature is locked. At that point, the instrument is ready.
Click Run in the SECTOR Imager window. The Run Options dialog window will open ( Figure 5:8
).
1. Verify Setup Selections. If changes are necessary, click Cancel, make changes in the area ( 5.2 Setup ) of the SECTOR
Imager window, and re-verify Setup Selections.
2. Run name is optional, but one can be entered in the second section.
3. Verify the Export information and make changes if necessary. (Refer to the DISCOVERY WORKBENCH User Guide for
additional details.) The export selections control the format and the location of the exported text data file that will be created
when the demonstration plate is read.
4. Click
OK
. The plate read starts. View the status in the lower left region (Status bar) of the DISCOVERY WORKBENCH
software to monitor progress. When the plate read is complete, the demonstration plate is returned to the stacker and
Run
is
enabled again.
5.3.1
Operations
The Pause, Stop, Eject, and Retract buttons operate the motion control system that moves plates through the instrument.
• Pause. Pauses the plate read. Selecting Pause again resumes the read.
• Stop. Stops the current run and ejects any plate inside the instrument.
• Eject. Transfers a plate from inside the instrument (but not being read) to the stacker output port where it may be retrieved.
This function is disabled during a plate run.
• Retract. Moves a plate from the input port into the instrument. No further action is taken without input from the operator.
This function is disabled during a plate run.