MSA Phalanx Alpha, Инструкция-перечень запасных частей

Страница: 3 / 14

6. Never alter or modify this device.
7. This respirator is for use by trained, qualified personnel only.
8. This facepiece does not provide any protection against propelled or
falling missiles. Consequently in riot or similar situations it is impera-
tive that a riot faceshield be worn in conjunction with the mask for pro-
tection against propelled or falling missiles.
FAILURE TO FOLLOW THE ABOVE WARNINGS CAN
RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
Respirator Fit Test
A qualitative or quantitative respirator fit test must be performed for each wear-
er of this respirator to determine the amount of protection it will provide.
Respirator fit tests are explained fully in the American National Standard for
Respiratory Protection, ANSI Z88.2, which is published by the American
National Standards Institute, 11 West 42nd Street, New York, New York 10036.
Quantitative Test
If a quantitative fit test is used, a fit factor that is at least 1000 shall be obtained
before that respirator is assigned to an individual.
Qualitative Test
If a qualitative fit test is used, only validated protocols are acceptable. The indi-
vidual must pass a test designed to assess a fit factor of at least 1000.
The user must perform a respirator fit test and follow all warnings and limita-
tions specified. Failure to do so can result in serious personal injury or death.
PREPARATIONS FOR USE
There are five inspection points, listed below, that must be checked before
donning the respirator. Under no circumstances should a respirator that fails
inspection be used. The respirator must be repaired or replaced.
1. Head harness: Check to see that the head harness straps still have their
elasticity. Inspect for cracks or tears and make sure all buckles are in place
and working properly.
2. Facepiece: Check facepiece for dirt, cracks, tears or holes. Inspect the
shape of the facepiece for possible distortion that may occur from improp-
er storage and make sure the rubber is flexible, not stiff.
3. Inhalation and exhalation valves: Check for cracks, tears, distortion, dirt or
build-up of material between valve and valve seat.
4. Facepiece inlet port: Check to make sure gaskets are in place (if applicable)
and check for cracks and damage to threads.
a.
Inlet Port (Phalanx Beta only): Check to make sure gasket is in place
and check for traces of damage to inlet components.
b. Inlet Port (Phalanx Alpha only): Check to make sure the inlet port
threads are free of damage such as crossed threads and that the can-
ister sealing surface of the facepiece is clean and free of dirt or other
foreign matter. Make sure the inlet port plugs are in place on the side of
facepiece opposite the canister.
TAL 704 (L) Rev. 11 - 487373
3
WARNING