608 Series
Heavy Duty Switch Bollard
INSTALLATION INSTRUCTIONS
8701 Castle Park Drive
Indianapolis, Indiana 46256
Telephone: (800) 842-2545/(317) 842-2545
www.mssedco.com
Page 2
(/MANU) 608v0808
PLASTIC CAP
TRANSMITTER AND
SPACER PLATFORM
PRESS
9V
PCB
300MHz
390MHz
HDRC™
FREQUENCY SELECTION
SWITCH
1 2 3 4 5 6 7 8 9 10
11
12
O
N
12 POSITION SECURITY
CODE SWITCH
ClearPath
™
HDRC™ Program 1-12
300 MHz Program 1-10
390 MHz Program 1-12
BATTERY HARNESS
Section 3
Wiring
HARDWIRED
1) Connect the two signal wires to the appropriate contacts on the switch. (Standard connections are COM and N.O.)
2) Set the spacer platform (provided) in the top of the switch bollard opposite to the cap mounting holes.
3) Install the cap and fasten with the two 8-32 x 1/2" screws provided.
NOTE:
Two signal wires are required per switch on vestibule models.
RADIO CONTROL (WIRELESS)
When a ClearPath radio transmitter option is ordered from the factory, the 608 series bollard will come complete with
the transmitter and battery mounted on its platform ready to be installed under the plastic cap. The CP/TX-P, CP/STX-P
(vestibule sequencing version), and CP/TX-VP (2 transmitters) feature 3 selectable frequencies in a single device: High
Definition Radio Control™ (HDRC™), 300 MHz and 390 MHz.
1) SELECT FREQUENCY: Select the desired frequency, via the 3-position slide switch on the transmitter circuit board
(Fig. 1). HDRC™ is factory setting.
FIGURE 1
2) SELECT SECURITY CODE: Program the desired security code, via the 12 dip
switches on the transmitter circuit board (Fig. 1).
NOTE:
For sequencing transmitters refer to CP/STX-P installation
instructions for proper programming.
3) Plug the 2-lead transmitter wiring harness onto the "COM" (Common)
and "N.O." (Normally Open) contacts located on the door activator's
microswitch.
4) Set transmitter platform in the top of bollard opposite to the cap screw holes.
5) Install the cap and secure it with the two 8-32 screws provided.
NOTE:
Vestibule switch bollards are supplied with two transmitters
(one per switch).
NOTICE:
This device complies with Part 15 of the FCC
rules. Operation of this device is subject to the
following two conditions: 1) This device may not
cause harmful interference and 2) This device
must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly
approved by MS SEDCO could void the user’s
authority to operate this equipment.
!
!
!
!
HDRC™:
MS SEDCO proprietary technology
300 MHz:
Compatible with Multicode™ products
390 MHz:
Compatible with MS SEDCO and GENIE™ products
MICROSWITCH ASSEMBLY
ClearPath
™
MICRO-SWITCH
UL LISTED
SPDT, Momentary
RATED: 15A @ 125V A C
COM
N.C.
N.O.
Rubber Bellows
Insert rubber bellows
over spring on
exterior switches for
weather tight fit!
