MRMC MRMC-2118-00, Быстрый старт

Страница: 9 / 36

Round Rail Quick Start Guide
5
Anchoring the track
Secure the track to the floor by using bolts or screws through the six track
anchor brackets. Anchoring the track to the floor gives you more
repeatable stability than using weights. The following procedure tells you
how to anchor the track to a concrete floor.
2. On one of the track anchor
brackets, screw the sleeve all
the way down to the floor,
finger tight.
3. Insert the drill bit and guide
into the threaded sleeve on the
anchor bracket, so the drill bit
is against the floor.
4. Put tape around the drill bit 5
cm above the guide. This will
help you gauge the depth of the
hole in the next step.
5. Drill a hole 5 cm deep into the
concrete. When the tape reaches the top of the guide, drilling is
complete.
6. Remove the drill bit and guide from the sleeve and clean the hole.
1. Put the drill bit into the drill guide and attach
the bit to the drill. (The cutting end of the bit is
too large to fit through the guide, so you must
insert the other end into the guide, then into
the drill.)
1
Guide
15 mm drill bit
Guide
Sleeve
2
3
5 cm
Tape
4
5 cm
4
5