MRC MTX5000, Руководство пользователя и техническое руководство

Страница: 58 / 150

Routine Operation 3-24 MTX5000 User and Technical Manual
Damage to the color LCD display panel
caused by using a hard-pointed object or
other misuse may void your warranty on
the MTX5000 IDU.
Note
If you are connected to the Ethernet via the IDU
rear panel
ETHERNET RJ45 connector and you
find that the color LCD display panel appears to be
operating very slowly or has locked up completely,
disconnect the Ethernet cable from the
ETHERNET connector.
This should free up the color LCD display Panel
and the IDU should resume proper operation.
Once the MTX5000 is powered up, you will be able to check its
configuration and monitor and control its operation in the local
operating mode.
The procedures required to use the Main and Status screens in
the local operating mode are as follows:
Topic Page
Select Preset 3-24
Select RF Band 3-27
Select/Customize Operating Channels 3-30
Select Channel Offset 3-32
Select Antenna 3-33
Select Antenna Polarization 3-34
Enable/Disable Transmitter 3-35
Select High/Low Power Mode 3-36
3.6.1 Select Preset
During performance of this procedure, you may select from a list
of factory
Default Presets or from a list of custom User Presets.
Factory Default Presets are identified alphabetically from Preset
A thru Preset J . Custom User Presets are identified numerically
from Preset 1 thru Preset XX , with “ XX ” being the last Preset
available.
Notes If selecting factory Default Presets in the following
steps, Preset J is not currently active.
Preset F and I are active only if your MTX5000 IDU
contains the applicable licensed factory options.
The procedure required to select a different Preset is contained
in the following steps. You can select a different Preset from a
list of factory-configured Presets and multiple custom Presets.
When performing the following steps, a Main option button to
Monitor ODU Status 3-36
Monitor IDU Status 3-37
Monitor SUM Errors 3-38
Monitor Current Preset Status Settings 3-38
Perform PA Voltage Adjust Setup 3-44
Perform RF Level Adjust 3-49
Select Color Bar Generator Mode 3-52
Set Time and Date 3-54
Perform IDU Diagnostics 3-56
Review System Information 3-57
Set Last PA State 3-58