•
Press the select button
to choose the rotation speed unit as xg. Relative centrifugal force enters
into the adjustment mode if the centrifugal acceleration value flashes.
•
The centrifuge enters into operation mode if there is no activity for about 7Seconds
•
Turn the parameter adjustment knob
to adjust the relative centrifugal force in the increments of
100xg.
(3) Set the operating conditions
See Section 8.1 for operation of other parts.
8.3 Transient operation
This function is generally used to remove the samples attached to the inner wall of the centrifuge tube and
can also meet the application requirements for transient centrifugation.
(1) Switch power On, fix the rotor on the main shaft, tighten the rotor cover firmly and close the upper
cover.
(2) The centrifuge enters into the operation mode and displays the last set parameter values, and allows to
reset the target rotation speed.
(3) Press and hold the pulse key
to increase the rotation speed until the set rotation speed is
achieved. Release the
key to start decelerating and shutdown.
9. Cleaning & Maintenance
9.1 Cleaning
Caution
•
Cleaning or sterilizing the centrifuge without complying the instructions contained herein might cause
damage to the centrifuge.
(1) Centrifuge
•
The color of housing might change and the label thereon might fall off if the centrifuge is exposed to
ultraviolet for a prolonged period of time. Please cover the centrifuge with a cloth to avoid the
exposure to light after use.
•
If the centrifuge becomes dirty, please clean it using a cloth/ sponge soaked with neutral cleaning
agent.
•
The centrifuge can be sterilized using a cloth soaked in 70% alcohol solvent.
Reminder: this key works only when the rotor is inactive and the outer lid is locked firmly.
