⚫
Do not exceed the actual tube capacity as mentioned in this user manual.
7.3 Ensure the balanced centrifuge tube
⚫
Although the centrifuge may be used with visually confirmed balance, it is recommended that the
samples are weighed using a balance to keep this centrifuge in a well-balanced condition to extend its
life expectancy.
⚫
Never intentionally run the centrifuge under an imbalance condition even though the allowable
imbalance is not exceeded.
7.4 Check rotor
Ensure to check the rotor for any corrosion or scratch before every operation.
Caution
⚫
If any corrosion or scratch is found on the rotor, please cease to use the rotor.
⚫
Avoid the use of other manufacturer’s rotor on this centrifuge.
7.5 Symmetrically load centrifuge tubes into rotor
Caution
⚫
Ensure to secure the rotor on the main shaft firmly. Otherwise, the rotor might fall off while the
centrifuge is in operation, resulting in damage to the centrifuge or rotor.
⚫
Tighten the rotor lid to the rotor firmly.
8. Operation
8.1 Normal operation
The display screen is lit when the power switch is turned ON, and the centrifuge shows HELLO page, as
shown in Fig. 8.1.
Caution
⚫
Avoid moving the centrifuge when it is in operation mode.
⚫
Keep the centrifugal chamber clean and ensure to remove foreign particles from the centrifugal
chamber, such as fragments of broken centrifuge tubes if any.
⚫
If any abnormal/ strange noise is noticed from the operating centrifuge, stop the operation
immediately and contact your service provider/ local supplier and also intimate the failure code
indicated if any.
⚫
