3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529
com
.
mrclab
@
mrc
Section 6
Operation
The chapter introduces the display window and the operation of
buttons of the dry bath with constant temperature.
Examination Before Start-Up
Confirm the following before inserting the plug into the power
socket.
1.
Ensure the power source is in accordance with the voltage
requirement of the instrument (refer to Features section for
voltage requirements).
2.
Make sure the plug has been fully plugged into the power
socket.
3.
Ensure the power line has been reliably grounded.
Caution
If the display of the instrument is abnormal after startup,
turn off the power source immediately and contact the supplier.
Start-Up
Press the power switch and the instrument will power on. All
indicator lights will be turned on. About 3~5 seconds later,
temperature display window will show the real-time temperature. All
indicator lights will be turned off.
Set the Temperature Value
The setting temperature range is: 5°C Above ambient to 150°C.
Press “
▲
” or “
▼
” to increase or decrease the temperature value, the
“OUT” indicator will be turned on or flashing, when the instrument
temperature is stabilized, the “OUT” indicator will flash Intermittently
Caution
DO NOT change any parameters in the controller apart from
the temperature setpoint (SV)
