MRA 4025066167111, Инструкция по монтажу

Страница: 3 / 8

3
GB
MOUNTING INSTRUCTIONS
BMW R1250R 2019-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number Article Article No.. Required tools
1 MRA windscreen --- Allen key 3mm
Torx 25
1 Reinforcing plate 11409
4 Neoprene washer 16x4.5x4mm 10634
4 Lens head screws, M5x20mm 10673
2 O-rings, 4.5x1.5mm 10992
4 Plastic discs 12x5x0.5mm 10635
1 Edge protection strip with clamping
sleeves
---
Fitting the fairing screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original screen (P1).
3. Insert the supplied M5X20mm fillister head screws with the plastic washers into the
lower and upper holes. Push the supplied rubber spacers against these from behind
(P2)
4. Place the supplied reinforcing plate onto the upper screws and secure the plate with
the supplied O-rings (P3).
5. Attach the MRA windscreen with the reinforcing plate to the motorcycle.
Tip: First, screw all fastening screws into the holes for a few thread lengths;
then, fully tighten the screws.
6. Pull the edge protection strip to the rear end of the screen. The clamping sleeves are
stuck onto the ends and pushed together slightly, so that the edge protection strip is
stuck to the screen.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de