GB
MOUNTING INSTRUCTIONS
YAMAHA MT 09 (T / VT)
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number
Article
Article No..
Required tools
1
MRA screen
---
Allen key 3, 4, 5mm
Screw Wrench 8mm
1
Pair of holding plates
10963
1
Traverse
11003
4
Hexagon socket screw M5x10
10998
4
Nuts M5
11000
4
Washer 5mm
10999
4
Oval-head screws M 5x16
10554
4
Plastic washers 5mm
10635
4
Rubber nuts M5
10629
1
Edge protection strip, clamp sleeves
---
Fitting the screen to the motorcycle:
1. Fasten the holding plates using the original screws (do not yet tighten) and insert the
rubber nuts in the holes (P1).
2. Fasten the traverse with the hexagon socket screws M5x10, the washers and the nuts
M5 and now tighten the original screws (P2).
3. Position the MRA windshield as required and fasten it with the screws M 5x16 and the
plastic washers.
4. Pull the edge protection profile to the rear, open area of the screen, beginning from
the lining transition to the opposite side. Cut off the excess if necessary.
5. Push the clamp sleeves over the ends of the edge protection profile and press them
gently together with combination pliers so that the edge protection profile is
clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: [email protected]
2
